132996130.qxd 17/05/01 9.13 Pagina 25 (Nero/Process Black pellicola)
If only a cold water supply is available, connect the twoWhen discharging into a standpipe ensure that the top of
hoses to a cold water outlet by means of a ?Y?the curve in the hose end is no more than 90cm (35.4'')
connection piece.and no less than 60cm (23.6'') above floor level. The
upright standpipe should have a minimum length of
Installation should comply with local water authority
30cm (12'') from the bottom of the elbow to the top of
and building regulations? requirements.
the pipe (see diagram).
The appliance must be given a separate cold water
Make sure that it is designed in such a way, that the end
supply and not be connected to a mixer tap, a single
of the drain hose cannot be covered with water.
outlet water heater or a booster pump. A minimum
water pressure of 0.48 bar is required for safe operation
of the appliance.
-
If you cannot make the cold water connection direct
from the rising mains, you may be able to operate the
appliance from your cold water storage system.
There should be a minimum distance of 5.02m
-! "
(16.5 ft) between the appliance?s inlet and the bottom of #
- #
the water storage tank.
There will be sufficient pressure for the hot waterThe drain hose may be extended to a maximum of 4
metres. An additional drain hose and joining piece
supply, providing there is a minimun height of 2.74
metres (9 ft) between the bottom of the cold wateris available from your local Service Force Centre.
storage tank and the bottom of the hot water cylinder.The joining piece must have an internal diameter of
18mm.
Set the hoses correctly by loosening the ring nuts. After
positioning the inlet hoses, be sure to tighten the ringIf you intend the drain hose to empty into a sink, make
nuts again to prevent leaks.sure that the sink is empty and the plug hole is not
blocked. Use the plastic ?U-Piece? supplied.
Water drainageImportant
Before connecting up the machine to new pipework or
This appliance is designed to be permanently plumbed
to pipework that has not been used for some time, run
into your home's water supply and drainage system.
off a reasonable amount of water to flush out any debris
The appliance drain hose should hook into a standpipe,
that may have collected in the pipes.
the hook in the drain hose is formed using the plastic
?U-Piece? supplied.
The standpipe should have an internal diameter of
approximately 38mm (see diagram) thus ensuring there
is an air break between the drain hose and standpipe.
-
-
25 |